Hi Jake,<div><br></div><div>We measured the resistance and it was an open circuit. The temp sensor was showing ambient of 19.2C. </div><div><br></div><div>Steve<br><br>On Friday, November 1, 2013, Jake  wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
Hol,<br>
<br>
you forgot to put any text in your post at all!  please be clear of how you came to this conclusion.<br>
<br>
The heating element is a resistor glued into a block of metal on the end of the extruder.  It has two wires which go to a connector a couple inches from it, and they go back to the machine.<br>
<br>
To test the heating element, one can unplug this connector and use a multimeter to measure its resistance.  It should be something like 8 ohms, i don't know the exact value but 100 is too much and indicates it's bad.<br>

<br>
it was replaced a little while ago by a technician from the corporation that made it.<br>
<br>
If the machine is acting up about heating, we need to know whether the problem is with the heating or the temperature sensing.  If the temperature sensor is reporting ambient temperature, it's probably working.<br>
<br>
if the temp sensor is working but the heating element isn't making it heat up, it could be the heating element (see test above) or it could be the connector near it, or the wires from there back to the main board, or where those wires connect to the brain.<br>

<br>
can you give more information about what you tried and what you observed?<br>
<br>
-jake<br>
______________________________<u></u>_________________<br>
sudo-discuss mailing list<br>
<a>sudo-discuss@lists.sudoroom.org</a><br>
<a href="http://lists.sudoroom.org/listinfo/sudo-discuss" target="_blank">http://lists.sudoroom.org/<u></u>listinfo/sudo-discuss</a><br>
</blockquote></div><br><br>-- <br>-steve<br>