<div dir="ltr"><div>@robb eeeh, not quite.</div><div><br></div><div>@jake 4 bad USB cables then 1 mediocre one? Dunno, theories:</div><div>1) <br></div><div>USB Connector is worn and the cable needs to have good springyness to make contact.</div><div><br></div><div>2) <br></div><div>The power supply in the cutter is dying and causing power sags,</div><div>the higher quality cable is more fault tolerant when this happens.<br></div><div><br></div><div>In the end, stalling still occurred with the best cable. Other problems observed, despite various</div><div>focal lengths I had to cut <30% speed, 100% power 4-5 passes to cut 1/8" acrylic.</div><div>In the past I would have cut this with round 40/60 3 passes. This could be mirror focusing, which</div><div>I didn't have time to perform. I also noticed a burnt spot on mirror #2.</div><div><br></div><div>Between stalling and burnt mirrors I'm going to go out on a limb and say this is unsafe to use</div><div>until a major overhaul is performed.<br></div><div><br></div></div><br><div class="gmail_quote"><div dir="ltr">On Tue, Oct 2, 2018 at 5:52 PM Jake <<a href="mailto:jake@spaz.org">jake@spaz.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">jeez do you think it was a bad USB cable or a coincidence of something else<br>
going wrong?  were you using your own computer or the dedicated desktop?<br>
<br>
On Tue, 2 Oct 2018, Morgan Allen wrote:<br>
<br>
> Of course I try "just one more cable" and it works. It shockingly lives<br>
> another day.<br>
><br>
> On Tue, Oct 2, 2018, 5:17 PM Morgan Allen <<a href="mailto:morganrallen@gmail.com" target="_blank">morganrallen@gmail.com</a>> wrote:<br>
><br>
>> Trying to get through a project but the laser isn't behaving. Stalls<br>
>> during a cut (with laser on of course) but manages tp start back up a dozen<br>
>> times before just stopping and burning a hole in the piece. Tried 4 or 5<br>
>> usb cables with varying results but still couldn't get a complete cut<br>
>><br>
><br>
</blockquote></div>