I flashed a new router tonight, and here is my so so report.
1. Uploading not working on Ubuntu Spanish version, I used Firefox.
After five or six resets and not being able to upload the firmware, I switched to a MacOS machine.
It just came to mind that, perhaps, Firefox in the Ubuntu machine, needed JavaScript enabled.
2. Using Brave browser, on MacOS Mojave 10.14.6, the upload and countdown worked on the first try, and the rest of the process went fine.
3. It produces a bit of wonder when connected to the PON SSID was just out, and not connecting to the Internet yet.
I didn't know how long would the auto-configuration would take. Even now I am not sure how long it took. 15mins? 10?
4. About the paragraph that says:
“Note: If you installed release 0.3.0 for myNet N600 routers, your node can be autoconfigured. You will not need to use the previous solution makenode, otherwise you may need to read the (instructions further down)”
Can that all be removed or modified with something shorter or like this?:
Note: If you did NOT install release 0.3.0 for myNet N600 routers, please skip this section and go to step: “Blah Blah”. 5. An observation:. When connected the node, via ssh, I found the "
config_succeeded" file with instructions on how to update passwords, and says to delete the line that reads "* */12 * * * /opt/mesh/pw_reset"
But, when checking cron, the only line there says: "0 * * * * /opt/mesh/pwd_reset"