Jake,

Hello, thanks for the replay. I do have experience with stuff like that. I actually have experience with stuff like that. I have my own shitty printer that’s a Tevo Tarantula; that one runs on Marlin (I think I recently uploaded 1.1.4). I’m still upgrading it though mechanically. I usually use Cura 3.1.0 for my slicer and have the usual Tarantula slicer for that. I also previously had an Anet A8 but that one was breaking down so often I ended up getting the Tarantula and sold my old one to a friend. I’ve heard different things about it including that it’s still broken or it’s fixed. Use the computer with a direct link instead of using the SD card. I was just looking for some kind of clarification. What kind of software you guys use to slice and all that good stuff.

Thanks again,

Paul Orozco

Sent from Mail for Windows 10

From: Jake
Sent: Sunday, January 28, 2018 10:02 PM
To: Paul Orozco
Cc: sudo-discuss@lists.sudoroom.org
Subject: Re: [sudo-discuss] Sudo Room 3D Printer Questions

Hi Paul,

i'm happy to report that the nozzle heater resistor was recently replaced, so

as far as i know there is nothing wrong with the printer except that it hasn't

been used in a long time, so there's probably a lot of dust on the filament and

the print bed, and maybe the nozzle is clogged.

do you have experience using a 3D printer like ours, which is a TAZ 3 running

Marlin firmware?  I'm guessing it will take a little bit of fiddling to get the

first prints to come out well.

I'll be hosting Hardware Hacking Tuesday this week at 7PM and you're welcome to

come then and try to use the 3D printer.  I can help a little bit while you're

working on it, and there may be others who can help as well.

-jake

On Sat, 27 Jan 2018, Paul Orozco wrote:

> Hello everyone,

>

> I'm a little new and I'm just wondering what's the status of the 3D Printer

> over here. I've heard it's broken right now, so I'm wondering what it'll

> take to fix it and be able to use it.

>

> Paul Orozco

> Cell: (916)337-7101

>