I will see your update and raise you another update. The issue came back despite the loosening of the screws.

On Jul 6, 2014 10:55 PM, "Matthew Senate" <mattsenate@gmail.com> wrote:

Follow up: seems like there was a bit of tension on the lumber that spans most of the height of the door, attached at the bottom to the motor (and thus the bottom latch) and attached above to the top latch.

A small metal piece that acts as a guide to this piece of lumber was especially tight, so we loosened the screws on it no more than a turn each, which seems to have allowed a bit more give.

In conclusion, this may or may not have been the problem, and perhaps there are other problems, but the mechanism seems to  be working at the moment. Unless, on the other hand, Andrew any more information to report.

// Matt

On Sun, Jul 6, 2014 at 5:01 PM, <hol@gaskill.com> wrote:

what kind of motor is it?

 

 

On 2014-07-06 03:45, Andrew wrote:

I've been working on the door access system all night. Everything was working fine, but now close works, but open does not, the motor just stops half way. I'm sorry for the inconvenience, but I have to stop working on this and come back tomorrow.

Until then I have disabled the mag swipe to prevent any damage to the system.

 

Thanks,

Andrew

--
-------

Andrew Lowe

Cell: 831-332-2507

http://roshambomedia.com

 

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://lists.sudoroom.org/listinfo/sudo-discuss

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://lists.sudoroom.org/listinfo/sudo-discuss

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://lists.sudoroom.org/listinfo/sudo-discuss