I’d like to learn how to cut a stencil or engrave with the robot arm - are you doing this during weekday evenings or weekends?  alice

On Feb 22, 2016, at 5:09 PM, hol@gaskill.com wrote:


Hey Adam,

I was about to cut a stencil on the laser when I noticed the cut head was bumping up against the left side and stalling the motor. I looked and sure enough the steel leaf of the switch was twisted downward. I was able to jog the head left while holding the limit switch down so I assume the unit needs to be replaced. Do you know if there are any spares at sudo? I have some from open source hardware that look similar but didn't want to attempt taking off the rail to get at it and making it worse.

Cheers,

Hol
_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://sudoroom.org/lists/listinfo/sudo-discuss