Thanks Jake! I was planning on doing it by hand, but it would be neat to try the mechanical one at sudo room.

Trent

On Thursday, September 22, 2016, Jake <jake@spaz.org> wrote:

a hotplate covered with clean sand heated up to 400 degrees (celsius) will be a surface on which you can place a circuitboard covered with such switches, and then you can pluck them out of the board as their solder melts.  This is how old boards had their parts salvaged from them back when people still did that.

if you don't have the right hotplate and you want to use a skillet instead, you'll likely have to cut the circuitboard in half or thirds so that it will be small enough to fit in the skillet of sand.  no big deal.

you could also remove them one at a time, using a desoldering tool. There's a motorized one at sudoroom, which is basically a gun-shaped soldering iron with a hollow tip and a foot-pedal activated vacuum pump. You could use that to pull the solder out of the hole for one of the two pins of each key, and then use a regular soldering iron to heat up the second one while pulling the key out with the other hand.

good luck,
-jake

On Tue, 20 Sep 2016, Trent Robbins wrote:

Does anyone know a good way to salvage from 101-105 mx brown keyboard
switches?

I'm planning on building my own keyboard this fall or winter and have
plenty of time to source scrap.

http://cubiq.org/build-your-very-own-pc-keyboard

Build process is as complex as you'd expect.

Teensy firmware: https://github.com/tmk/tmk_keyboard



Trent

--
(Sent from cellphone)

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://sudoroom.org/lists/listinfo/sudo-discuss