We haz plenty of spray adhesive for art

On Wed, Mar 21, 2018, 2:50 PM Jake <jake@spaz.org> wrote:

would not Silicone Caulk make an ok adhesive?  mechanically pressing against
the glass with an open-cell foam pad seems smart though to provide some
insulation on the bottom of the heater anyway.

On Wed, 21 Mar 2018, Adam wrote:

> Nope, just finding a good adhesive for reattaching it is hard. I ended up
> just using an open cell foam pad to push the header on the glass
> mechanically.
> Only advice is to not be too aggressive and let the glue take its time to
> release. Doingbot while warm would help.
> On Mar 21, 2018 1:34 PM, "Marc Juul" <marc@juul.io> wrote:
> Cool! Hey is there any reason why I can't do that end then just flip the
> glass, clean it and re-attach the heating pad on the bottom?
> Any tips on getting the heating pad off?
> On Wed, Mar 21, 2018 at 11:34 AM, Adam <me@adammunich.com> wrote:
>> I have successfully separated the heating pad from my old Taz bed it's
>> quite robust
>> On Mar 21, 2018 8:10 AM, "Marc Juul" <marc@juul.io> wrote:
>>> On Wed, Mar 14, 2018 at 3:51 PM, Jake <jake@spaz.org> wrote:
>>>> I 3d printed stuff last night and it worked great.  I scraped off the
>>>> stuff on
>>>> the print bed and exposed the actual glass print bed!  it's still good
>>>> except
>>>> there are a couple of serious craters.  Not sure what to do about the
>>>> craters,
>>>> perhaps fill them in with caulk?  Silicone caulk sticks to glass.
>>> Yeah sorry about that. One of the craters is my fault. I was printing on
>>> a really cold night with ABS and the ABS stuck so well to the glass and the
>>> temperature difference in the room was so great that the ABS contracting as
>>> it cooled actually took off a bit of the glass. I will try to find and
>>> order replacement glass.
>>> _______________________________________________
>>> sudo-discuss mailing list
>>> sudo-discuss@lists.sudoroom.org
>>> https://sudoroom.org/lists/listinfo/sudo-discuss
sudo-discuss mailing list