Trying here - noticed after I set it up at home that bead does not heat. No voltage on the terminals inside the controller either, is there a setting that can be changed via USB but not via the lcd screen menu? I always just print from SD, noticed the temperature settings were off to vs. last time I used it so will try this route. Nozzle is heating up just fine so assuming power is nominal and it's a software issue.

On 2016-09-21 08:42, robb wrote:

make your daughter happy!

On Tue, Sep 20, 2016 at 10:14 AM, <hol@gaskill.com> wrote:

Working on an LED baby toy for my daughter, getting a bit more complicated than I thought and not easy to go back and forth between sudo and home. Anyone have imminent prints to do on the TAZ? Would bring back this weekend at the latest.

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://sudoroom.org/lists/listinfo/sudo-discuss