i think it will allow you to jog left even if the switch is pressed.  i know it's dumb but i think it only looks at the switch when it is homing itself.  I could be wrong.

if not i can certainly bring a replacement but i'll have to see the old one first.  or check those plastic 3d printers from 3dsystems that are kicking around.

-jake

On Mon, 22 Feb 2016, hol@gaskill.com wrote:

Hey Adam,
I was about to cut a stencil on the laser when I noticed the cut head wa
s bumping up against the left side and stalling the motor.  I looked and
 sure enough the steel leaf of the switch was twisted downward.  I was a
ble to jog the head left while holding the limit switch down so I assume
 the unit needs to be replaced.  Do you know if there are any spares at sudo?  I have some from open source hardware that look similar but didn'
t want to attempt taking off the rail to get at it and making it worse.
Cheers,
Hol

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://sudoroom.org/lists/listinfo/sudo-discuss