@robb eeeh, not quite.

@jake 4 bad USB cables then 1 mediocre one? Dunno, theories:

1)

USB Connector is worn and the cable needs to have good springyness to make contact.

2)

The power supply in the cutter is dying and causing power sags,

the higher quality cable is more fault tolerant when this happens.

In the end, stalling still occurred with the best cable. Other problems observed, despite various

focal lengths I had to cut <30% speed, 100% power 4-5 passes to cut 1/8" acrylic.

In the past I would have cut this with round 40/60 3 passes. This could be mirror focusing, which

I didn't have time to perform. I also noticed a burnt spot on mirror #2.

Between stalling and burnt mirrors I'm going to go out on a limb and say this is unsafe to use

until a major overhaul is performed.

On Tue, Oct 2, 2018 at 5:52 PM Jake <jake@spaz.org> wrote:

jeez do you think it was a bad USB cable or a coincidence of something else
going wrong?  were you using your own computer or the dedicated desktop?

On Tue, 2 Oct 2018, Morgan Allen wrote:

> Of course I try "just one more cable" and it works. It shockingly lives
> another day.
>
> On Tue, Oct 2, 2018, 5:17 PM Morgan Allen <morganrallen@gmail.com> wrote:
>
>> Trying to get through a project but the laser isn't behaving. Stalls
>> during a cut (with laser on of course) but manages tp start back up a dozen
>> times before just stopping and burning a hole in the piece. Tried 4 or 5
>> usb cables with varying results but still couldn't get a complete cut
>>
>

_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
https://sudoroom.org/lists/listinfo/sudo-discuss