On 2016-02-22 19:58, Adam wrote:

No idea, check the other one they're probably the same

On 22 Feb 2016 7:57 pm, <hol@gaskill.com> wrote:

normally open or normally closed?

On 2016-02-22 17:10, Adam wrote:

There might be a limit switch kicking around, but I haven't been to sudo in a long while so I'm not sure where.

Jake probably has one

On 22 Feb 2016 5:09 pm, <hol@gaskill.com> wrote:

Hey Adam,

I was about to cut a stencil on the laser when I noticed the cut head was bumping up against the left side and stalling the motor.  I looked and sure enough the steel leaf of the switch was twisted downward.  I was able to jog the head left while holding the limit switch down so I assume the unit needs to be replaced.  Do you know if there are any spares at sudo?  I have some from open source hardware that look similar but didn't want to attempt taking off the rail to get at it and making it worse.

Cheers,

Hol