Mesh/Mounting - Revision history

Eenblam: phrasing

2018-06-10T03:27:19Z

phrasing

← Older revision		Revision as of 20:27, 9 June 2018
Line 1:		Line 1:
	=Mounting Rooftop Nodes=		=Mounting Rooftop Nodes=

	~~Also~~, see https://github.com/sudomesh/mounting .		This wiki article is perhaps more accessible than GitHub, and content here is appreciated. However, please see also https://github.com/sudomesh/mounting .

	==Node Mount Inventory Checklist==		==Node Mount Inventory Checklist==

Dougwinter: /* 110v materials */

2018-03-25T20:43:21Z

110v materials

← Older revision		Revision as of 13:43, 25 March 2018
Line 47:		Line 47:

	=== 110v materials ===		=== 110v materials ===
	''Contingent on weather and roof conditions:''		''Contingent on weather and roof conditions, and assuming the need for extending 110v supply:''
	* 1x Receptacle, duplex		* 1x Receptacle, duplex
	* 1x weather-tite box, switch		* 1x weather-tite box, switch
Line 79:		Line 79:
	* Confirm breaker aligns with wire-size		* Confirm breaker aligns with wire-size
	(12g to 20 amp, 14g to 15 amp)		(12g to 20 amp, 14g to 15 amp)


	== Copied from [[Mesh/Flashing_extender_nodes]] ==		== Copied from [[Mesh/Flashing_extender_nodes]] ==

Dougwinter: added 110v materials list

2018-03-25T20:42:27Z

added 110v materials list

← Older revision		Revision as of 13:42, 25 March 2018
Line 46:		Line 46:
	* Work Boots		* Work Boots

			=== 110v materials ===
			''Contingent on weather and roof conditions:''
			* 1x Receptacle, duplex
			* 1x weather-tite box, switch
			* 1x weather-tite cover, switch
			* 1x weather-tite extension box, switch
			* 1box ground screws
			* 2x box connector
			* 50x exterior straps for:
			* 500 lf flexible conduit
			* 1 spool 12g thhn, red
			* 1 spool 12g thhn, black
			* 1 spool 12g thhn, white
			* 1 spool 12g thhn, green
			* 1 spool 14g thhn, red
			* 1 spool 14g thhn, black
			* 1 spool 14g thhn, white
			* 1 spool 14g thhn, green
			* 1 box yellow wire nut
			* 1 box red wire nut
			* 1 roll black vinyl tape
			* 1 box pan-head screw, 1"

			Conduit, depending:
			* ? Â½" EMT conduit ?
			* ? Â½" EMT straps ?
			* ? Â½" flexible weathertite conduit ?
			* ? straps for above ?

			ID appropriate circuit
			* Confirm meter source
			* Confirm breaker aligns with wire-size
			(12g to 20 amp, 14g to 15 amp)

Carratos: /* Tools */

2018-03-11T20:41:30Z

Tools

← Older revision		Revision as of 13:41, 11 March 2018
Line 18:		Line 18:
	* Wirecutters		* Wirecutters
	* Hammer		* Hammer
			* Compass
			* Binoculars

	=== Things to Attach Things to Other Things ===		=== Things to Attach Things to Other Things ===

Carratos: /* Tools */

2018-03-11T20:40:47Z

Tools

← Older revision		Revision as of 13:40, 11 March 2018
Line 18:		Line 18:
	* Wirecutters		* Wirecutters
	* Hammer		* Hammer
	* Compass
	* Binoculars

	=== Things to Attach Things to Other Things ===		=== Things to Attach Things to Other Things ===

Carratos: /* Tools */

2018-03-11T20:40:24Z

Tools

← Older revision		Revision as of 13:40, 11 March 2018
Line 18:		Line 18:
	* Wirecutters		* Wirecutters
	* Hammer		* Hammer
			* Compass
			* Binoculars

	=== Things to Attach Things to Other Things ===		=== Things to Attach Things to Other Things ===

Gcg: /* Copied from Mesh/Flashing_extender_node = */

2018-03-03T06:41:05Z

Copied from Mesh/Flashing_extender_node =

← Older revision		Revision as of 23:41, 2 March 2018
Line 46:		Line 46:


	== Copied from [[Mesh/~~Flashing_extender_node~~]] ===		== Copied from [[Mesh/Flashing_extender_nodes]] ==

	For some reason, this was hiding at the very bottom of the extender node flashing guide,		For some reason, this was hiding at the very bottom of the extender node flashing guide,

Gcg at 06:40, 3 March 2018

2018-03-03T06:40:31Z

← Older revision		Revision as of 23:40, 2 March 2018
Line 43:		Line 43:
	* High Visibility Clothing		* High Visibility Clothing
	* Work Boots		* Work Boots



			== Copied from [[Mesh/Flashing_extender_node]] ===

			For some reason, this was hiding at the very bottom of the extender node flashing guide,

			=== Installation Order ===
			#Flash home nodes and extender nodes
			#Get on roof and determine which direction to face the extender nodes
			#Install J-Pole
			#Crimp end onto Ethernet cable
			#Run Ethernet cable from j-pole down to location of home node (either through a soffit indoors or to an outdoor enclosure)
			#Crimp other end of Ethernet cable and connect to home node via a POE adaptor
			#Install extender node on J-Pole using zip-ties - check lights to make sure unit is powered up
			#Walk around the neighborhood to check the signal

			=== Gear Checklist ===

			Protective and personal gear
			*Wear clothes you can get dirty and sturdy boots for roof walking
			*Sunscreen
			*Sunglasses
			*Pocketknife (for cutting zip ties etc)
			*Ladder
			*Safety harness & rope in a bucket
			*Smart phone (to check signal and take pictures)
			Home node gear
			*2 flashed Western Digital Mynet N600 Home Nodes
			*paperclip (to reset equipment)
			*Laptop (to configure equipment)
			*Plastic outdoor enclosure for router (optional)
			*Power Strip
			J-Pole gear
			*J-Pole
			*Latex gloves (for dealing with roofing sealant)
			*Roofing sealant
			*Ratchet set - 10mm for small bolts, 13mm for large bolts
			*Corldless Drill
			*3/16" drill bit for J-pole bolts
			*Steel One-Hole Conduit Straps (for holding Ethernet cable along eves)
			*Screws for the Steel one-hole straps
			Ethernet cable gear
			*Ethernet Spool
			*Ethernet Ends
			*Ethernet Crimper
			*Laminated card showing the Ethernet cable order
			*Label Maker - so you can know which cable is which
			Extender node gear
			*Flashed Ubiquiti Nanostation M2 or M5 extender Node(s)
			*Power over Ethernet (POE) adapters
			*Zip Ties

Carratos: /* Safety Equipment */ Adding clothing and footwear

2018-02-18T22:20:56Z

Safety Equipment: Adding clothing and footwear

← Older revision		Revision as of 15:20, 18 February 2018
Line 42:		Line 42:
	* Safety Goggles		* Safety Goggles
	* High Visibility Clothing		* High Visibility Clothing
			* Work Boots

Jhpoelen at 21:34, 18 February 2018

2018-02-18T21:34:12Z

← Older revision		Revision as of 14:34, 18 February 2018
Line 1:		Line 1:
	=Mounting Rooftop Nodes=		=Mounting Rooftop Nodes=

			Also, see https://github.com/sudomesh/mounting .

	==Node Mount Inventory Checklist==		==Node Mount Inventory Checklist==