Difference between revisions of "Big red laser cutter"

Jump to navigation Jump to search
391 bytes added ,  13:59, 17 November 2021
no edit summary
Tags: Mobile edit Mobile web edit
(One intermediate revision by the same user not shown)
Line 6: Line 6:


Some of the software (downloaded from the above link) is on the hard drive of wasp.local which is a desktop computer under the 3D printer desk, in a folder called ~/laser-backup/
Some of the software (downloaded from the above link) is on the hard drive of wasp.local which is a desktop computer under the 3D printer desk, in a folder called ~/laser-backup/
it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine.  The same software might work over ethernet but we didn't try.
I cut some 1/4 clear plastic suspected to be acrylic. Used .5mm/sec 100%/40% power. It cut all the way through but the edge was rough.

Navigation menu