Difference between revisions of "Big red laser cutter"

Jump to navigation Jump to search
Tags: Mobile edit Mobile web edit
Line 8: Line 8:


it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine.  The same software might work over ethernet but we didn't try.
it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine.  The same software might work over ethernet but we didn't try.
I cut some 1/4 clear plastic suspected to be acrylic. Used .5mm/sec 100%/40% power. It cut all the way through but the edge was rough.