Difference between revisions of "Mesh/Flashing extender nodes"

no edit summary
 
Line 1: Line 1:
After following the [[Mesh/WalkThrough]], you are probably just an isolated node on the virtual People's Open Network. If you want to become part of the physical mesh, you are going to need to extend the signal from home node using what we call an extender node. An extender node is just a roof-mounted, directional antenna used to make point-to-point connections between two locations that have line-of-sight (LOS) to one another. Preparing an extender node generally consists to two stages, downgrading the proprietary AirOS firmware and flashing it with our custom build of OpenWrt.
After following the [[Mesh/WalkThrough]], you are probably just an isolated node on the virtual People's Open Network. If you want to become part of the physical mesh, you are going to need to extend the signal from home node using what we call an extender node. An extender node is just a roof-mounted, directional antenna used to make point-to-point connections between two locations that have line-of-sight (LOS) to one another. Preparing an extender node generally consists to two stages, downgrading the proprietary AirOS firmware and flashing it with our custom build of OpenWrt.


== Downgrading to earlier AirOS ==
== Downgrading to older AirOS ==


Typically, we use Ubiquiti equipment for our extender nodes. These come with a proprietary firmware called AirOS. Any extender node with version 5.6 of AirOS and above needs to be downgraded to a 5.5.XX version of AirOS version before you can flash it with OpenWRT.  
Typically, we use Ubiquiti equipment for our extender nodes. These come with a proprietary firmware called AirOS. Any extender node with version 5.6 of AirOS and above needs to be downgraded to a 5.5.XX version of AirOS version before you can flash it with OpenWRT.  
95

edits