Difference between revisions of "Mesh/Meraki Sparky Enclosure Design"

From Sudo Room
Jump to navigation Jump to search
Line 9: Line 9:
* the standoff extending from the top, but short enough to clear the PCB components
* the standoff extending from the top, but short enough to clear the PCB components
* the slots should be near the bottom of the box
* the slots should be near the bottom of the box
* the opening should have a curved front to acomadate the angled ethernet/power connections
* the opening should have a curved front to accommodate the angled ethernet/power connections
* the back should have a mounting hole for the antenna
* the back should have a mounting hole for the antenna

Revision as of 00:49, 6 December 2013

See Also: Mesh/Inventory

notes about an enclosure for the Maraki Sparky

first pass

Maraki Sparky box-1.jpg

The idea is for an enclosure that has a slot on the sides into which the Meraki Sparky can slide. Then there might be a single screw that can be inserted from the bottom in order to keep the PCB from sliding out. Next design should have:

  • the standoff extending from the top, but short enough to clear the PCB components
  • the slots should be near the bottom of the box
  • the opening should have a curved front to accommodate the angled ethernet/power connections
  • the back should have a mounting hole for the antenna