Difference between revisions of "Mesh/WalkThrough"

596 bytes added ,  21:27, 26 April 2016
m (minor formatting)
Line 76: Line 76:
The default settings in `settings.js` should suffice in most cases, but if you need to make changes, do them in 'settings.js'.  
The default settings in `settings.js` should suffice in most cases, but if you need to make changes, do them in 'settings.js'.  


A freshly flashed node will be setup on 172.22.0.1, so you will need to configure your machine to use IP address 172.22.0.9 (subnet 255.255.255.0, gateway: 0.0.0.0). Once your network configuration is refreshed, use the following command to run the script and configure your node:
A freshly flashed node will be setup on 172.22.0.1, so you will need to configure your machine to use IP address 172.22.0.9 (subnet 255.255.255.0, gateway: 0.0.0.0).
On your laptop (instructions for Ubuntu) edit your network settings by doing the following:
 
    Click on the network icon on the top right of the toolbar.
    Click "Edit connections..."
    Click on Ethernet connection "Wired connection 1" and click Edit
    Click on the "IPv4 Settings" tab
    Change method to "Manual"
    Click Add
    Under "Address" type "172.22.0.9"
    Under "Netmask" type "255.255.255.0"
    Under "Gateway" type "0.0.0.0"
    Click Save
    Click Close
 
Make sure the ethernet cable is connected to the 4th port on the router (closest to the yellow internet port).
 
Once your network configuration is refreshed, use the following command to run the script and configure your node:


   ./makenode.js
   ./makenode.js
76

edits