Difference between revisions of "Mesh/Flashing extender nodes"

Line 164: Line 164:


This will cause the [https://wiki.openwrt.org/doc/techref/bootloader/uboot U-Boot] bootloader to drop into a command line.
This will cause the [https://wiki.openwrt.org/doc/techref/bootloader/uboot U-Boot] bootloader to drop into a command line.
==== TFTP Serial Output ====
When booting with the reset button held down on a Ubiquity NSM5, the following output is displayed.
  U-Boot 1.1.4-s958 (Jun 10 2015 - 10:56:20)                                                                                     
 
  DRAM:  64 MB                                                                                                                   
  Flash:  8 MB (0xc2, 0x20, 0x17)                                                                                                 
  Net:  AR8236                                                                                                                   
  eth0, eth1                                                                                                                     
  Board: Ubiquiti Networks AR9342 board (e855-22585.1122.0030)                                                                   
  Radio: 0777:e855                                                                                                               
  Reset: Normal                                                                                                                   
  Hit any key to stop autoboot:  0                                                                                               
  Setting default IP 192.168.1.20                                                                                                 
  Starting TFTP server...                                                                                                         
  Using eth0 (192.168.1.20), address: 0x81000000                                                                                 
  Will reset device configuration (Reset button active after 10 seconds).                                                         
  Erasing sector 123..126                                                                                                         
 
  First 0x7b last 0x7e sector size 0x10000                                                                                       
  .... done


==== Transfering file to U-Boot over Serial ====
==== Transfering file to U-Boot over Serial ====


U-Boot supports two protocols for transfering files: kermit or y-modem. Minicom does not support the kermit protocol, however it does support the y-modem protocol.
U-Boot supports two protocols for transfering files: kermit or y-modem. Minicom does not support the kermit protocol, however it does support the y-modem protocol.
128

edits