[Mesh] Issue with node

[Scott Olsen]

My IP on pullwax is 172.30.0.174/24. I don't understand your solution -
both SSID (pullwax and peoplesopen.net) are from the same device, so
there is no way to install a router between the networks. Besides, I
don't really need a temp solution, it's not an issue for me if it
doesn't work - just wanted to let you know for troubleshooting of the
firmware. Have you experienced this issue in the other nodes?

On 04/05/2014 12:04 PM, Somebody wrote:
> Just out of curiosity, is the private network on the 10.?
>
> If so, perhaps a temporary solution could be to install a  router between the two 10. Networks.
>
>
>
>
> Scott Olsen <scott at veteranstechcollective.org> wrote:
>
>> Hi folks,
>> I just installed the node you lent me (14th Ave/E 27th). The private
>> network (SSID: pullwax) works great: I can connect to it, access the
>> internet, and log into the router admin interface. The peoplesopen.net
>> SSID is a different story. DNS resolution works and traffic (ping)
>> directly to the router works, but that's about all. I cannot access or
>> ping any internet hosts. My device is assigned an IP (10.0.26.201) and I
>> can ping the router at 10.42.10.10. Traceroute to internet hosts do not
>> even bounce off of the gateway 10.42.10.10. I think I'm at the end of my
>> ability to troubleshoot this issue further with my current knowledge of
>> the mesh system, just wanted to give yall a heads up.
>> Scott
>>
>>
>>
>> _______________________________________________
>> mesh mailing list
>> mesh at lists.sudoroom.org
>> https://lists.sudoroom.org/listinfo/mesh