[Mesh] Trouble with meraki board

[Matthew Senate]

I have no experience yet, only interest (in getting them working ;), but I
have a couple of questions:

(1) How are you powering the board--AC adapter or power-over-ethernet? (I'm
not sure POE works, would be great to know.)
(2) What sort of adapter are you using (i.e. did you have to manually set
the pins) and is it fully and properly connected (physically)?
(3) Does the board need to be set into a particular "flash" mode, as some
of the other routers, perhaps by pressing/holding a reset button?

Cheers,
Matt


On Fri, Jul 11, 2014 at 2:41 AM, Daphne Larose <daphne.larose at gmail.com>
wrote:

> Hey everyone!
>
> I've been trying to set up the Meraki Sparky board to flash the openwrt
> code to it, but when I connect the pins and plug in the usb adapter to my
> laptop and run the meraki-flasher script, I get this exception "SerialException('device
> reports readiness to read but returned no data (device disconnected?)')"
> and the green led on the meraki board isn't lit.  But $ dmesg | grep tty
> shows that it's connected.
>
> Does anyone have any ideas as to good way to pinpoint what the issue may
> be?  Not sure if the issue is the usb adapter I'm using or the board
> itself, but I was going to try buying another usb to ttl adapter tomorrow
> to see if that helps. Any advice would be awesome!
>
> It was nice meeting you all tonight!
>
> Daphne
>
> _______________________________________________
> mesh mailing list
> mesh at lists.sudoroom.org
> https://lists.sudoroom.org/listinfo/mesh
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://sudoroom.org/lists/private/mesh/attachments/20140711/27a2703a/attachment.html>