[sudo-discuss] lulzbot TAZ 3d printer is dead

[Hol Gaskill]

just popped by the space and noticed the air gap - should probably use some kind of high temp thermal grease.  my bet is that the heater was getting significantly above max temp but that heat wasn't getting conducted into the block and into the thermistor.  i'll check mine and bring in on saturday for omni hackathon with a side of 3ding - will you be around?  would also like to learn how to work with thermistors.

cheers

on May 01, 2014, Jake <jake at spaz.org> wrote:
>if the TAZ we has now has the 2.0 schnozzle then it might use the 4.7 ohm >resistor as seen here:>http://www.lulzbot.com/products/heat-resistor-47-ohm>>of course the printer will work with a different resistor as long as it >provides enough heat to print. Worst case we have to insert M220 S50 to >slow it down to half speed printing until we get a better resistor...>>what value resistors do you have? any special glue?>>On Thu, 1 May 2014, Hol Gaskill wrote:>>> this is what i pull up for the part - 6.8 ohm:>> http://www.lulzbot.com/products/heat-resistor-68-ohm>>>> sounds like the most common reason for these failing is over temp from miscalibrated>thermistor - i did find those 3 i got for the type a machine and if it's the same>part i'll bring them in.>>>> on May 01, 2014, Jake <jake at spaz.org> wrote:>>> so i spent all evening (and some of last night) to finally spool up the >gigantic>pile of black filament for the TAZ 3D printer.>>i finally got it hung from the wall>with a dust cover over it and ready to >feed smoothly into the printer, and then>i discovered that the heating >element in its extruder head is dead.>>oh well.>>so,>we need a new resistor to go in there. I don't know what the original >spec is, but>since the whole thing runs on 24VDC and assuming 24 watts of >heat, that would be>a 24 ohm resistor or so.>>Is someone other than me interested in contacting Lulzbot>and asking >whether they want to send us a new resistor, or if they can tell us what>>part number of resistor we should get as a replacement?>>-jake>>P.S. yes i tested>the resistor and it's dead, infinite ohms, it's burned >out. When we get a replacement>we can glue it in there better than they >apparently did. If the glue goes bad it>dies.>>>>