[sudo-discuss] sudo 3d printer missing driver boards

[Adam Munich]

The current calibration isn't much more than turning one trimpot, too
little current and the motor skips a beat, too much, and it gets too hot.
There's no difference in accuracy past a certain point.

---
Aperture Systems: Redefining Radiography -  http://aperture.systems/
http://adammunich.com/ - Cell: +1-650-452-0554

Be • knowledgeable •  social • patient • fearless • compassionate • fun •
humble • forgiving.

Be a leader

On Sat, May 23, 2015 at 9:07 PM, Jake <jake at spaz.org> wrote:

> haha i really don't think it's that kind of thing!  i'm guessing that
> someone took them out to use them in a different printer, and i want to
> figure out if they're bringing them back or not so i can plan on getting
> printer drivers back into this printer.
>
> they're the size of a postage stamp.  but when you put them back in the
> printer you have to calibrate the current to the motors, which i don't know
> exactly how to do.
>
>
> On Sat, 23 May 2015, Marc Juul wrote:
>
>  On Sat, May 23, 2015 at 8:27 PM, Jake <jake at spaz.org> wrote:
>>       i tried to use the wooden 3D printer and only the Y axis worked.
>>
>>       i looked in the side and saw that three of the four motor driver
>> boards are missing!  WTF?
>>
>>
>> Damn. We really need to get these new lockable doors between spaces.
>>
>> --
>> marc/juul
>>
>>
> _______________________________________________
> sudo-discuss mailing list
> sudo-discuss at lists.sudoroom.org
> https://sudoroom.org/lists/listinfo/sudo-discuss
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sudoroom.org/pipermail/sudo-discuss/attachments/20150524/46025448/attachment.html>