the transmission cable that goes from the overhead motor to the spindle was disconnected last I looked - might have to track it down.  good luck!

Dec 13, 2013 05:47:47 PM, yardenack@gmail.com wrote:
On Fri, Dec 13, 2013 at 5:35 PM, Jake jake@spaz.org> wrote:
>> anyone know how to use the CNC mill?  I am thinking of going to sudo tonight
>> to mill something and it would be easier if someone can show me how to do
>> it, rather than figuring it out.
>> or is there a wiki page for the thing?
>
>I know I replied on IRC, but for the benefit of future
>readers/archivers/crawlers:
>
>https://sudoroom.org/wiki/CNC
>https://sudoroom.org/wiki/O:55
>https://imgur.com/a/461VK
>_______________________________________________
>sudo-discuss mailing list
>sudo-discuss@lists.sudoroom.org
>http://lists.sudoroom.org/listinfo/sudo-discuss
>
_______________________________________________
sudo-discuss mailing list
sudo-discuss@lists.sudoroom.org
http://lists.sudoroom.org/listinfo/sudo-discuss