128
edits
Difference between revisions of "Mesh/Flashing extender nodes"
→Interupting Boot
Redconfetti (talk | contribs) |
Redconfetti (talk | contribs) |
||
| Line 160: | Line 160: | ||
Reset: Normal | Reset: Normal | ||
Hit any key to stop autoboot: 0 | Hit any key to stop autoboot: 0 | ||
Hit any key to stop autoboot: 0 | |||
ar7240> | |||
This will cause the [https://wiki.openwrt.org/doc/techref/bootloader/uboot U-Boot] bootloader to drop into a command line. | This will cause the [https://wiki.openwrt.org/doc/techref/bootloader/uboot U-Boot] bootloader to drop into a command line. | ||
==== TFTP Serial Output ==== | |||
When booting with the reset button held down on a Ubiquity NSM5, the following output is displayed. | |||
U-Boot 1.1.4-s958 (Jun 10 2015 - 10:56:20) | |||
DRAM: 64 MB | |||
Flash: 8 MB (0xc2, 0x20, 0x17) | |||
Net: AR8236 | |||
eth0, eth1 | |||
Board: Ubiquiti Networks AR9342 board (e855-22585.1122.0030) | |||
Radio: 0777:e855 | |||
Reset: Normal | |||
Hit any key to stop autoboot: 0 | |||
Setting default IP 192.168.1.20 | |||
Starting TFTP server... | |||
Using eth0 (192.168.1.20), address: 0x81000000 | |||
Will reset device configuration (Reset button active after 10 seconds). | |||
Erasing sector 123..126 | |||
First 0x7b last 0x7e sector size 0x10000 | |||
.... done | |||
==== Transfering file to U-Boot over Serial ==== | |||
U-Boot supports two protocols for transfering files: kermit or y-modem. Minicom does not support the kermit protocol, however it does support the y-modem protocol. | |||