Difference between revisions of "Mesh/Flashing extender nodes"

Mesh/Flashing extender nodes (view source)

2,587 bytes added , 21:27, 6 May 2016

128

edits

@@ Line 48: / Line 48: @@
 == Nanostation M5 ==
+=== Firmware check failure ===
 If you attempt to flash the extender and receive a 'Firmware check failed' error, then you have a version of the NSM5 that is protected from being flashed via the TFTP method. You will need to obtain a serial to USB interface (USB to UART TTL Module Serial Converter, 5 pin) and use it to flash the firmware.
@@ Line 56: / Line 58: @@
     Sending openwrt-ar71xx-generic-ubnt-nano-m-squashfs-factory.bin to 192.168.1.20 using tftp put
     [Error: (Server) Firmware check failed]
+==== TFTP Serial Output ====
+When booting with the reset button held down on a Ubiquity NSM5, the following output is displayed.
+  U-Boot 1.1.4-s958 (Jun 10 2015 - 10:56:20)
+  DRAM:  64 MB
+  Flash:  8 MB (0xc2, 0x20, 0x17)
+  Net:   AR8236
+  eth0, eth1
+  Board: Ubiquiti Networks AR9342 board (e855-22585.1122.0030)
+  Radio: 0777:e855
+  Reset: Normal
+  Hit any key to stop autoboot:  0
+  Setting default IP 192.168.1.20
+  Starting TFTP server...
+  Using eth0 (192.168.1.20), address: 0x81000000
+  Will reset device configuration (Reset button active after 10 seconds).
+  Erasing sector 123..126
+  First 0x7b last 0x7e sector size 0x10000
+  .... done
+  Waiting for connection: \
+  Receiving file from 192.168.1.10:49763
+  Received 4325788 bytes
+  Firmware check failed! (1)
 === USB to Serial Connection ===