Difference between revisions of "Big red laser cutter"

Big red laser cutter (view source)

136 bytes added , 12:59, 17 November 2021

no edit summary

311

edits

Revision as of 21:39, 26 October 2021 (view source) Jerkey (talk \| contribs) ← Older edit		Revision as of 12:59, 17 November 2021 (view source) Jerkey (talk \| contribs) Tags: Mobile edit Mobile web edit Newer edit →
Line 8:		Line 8:

	it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine. The same software might work over ethernet but we didn't try.		it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine. The same software might work over ethernet but we didn't try.

			I cut some 1/4 clear plastic suspected to be acrylic. Used .5mm/sec 100%/40% power. It cut all the way through but the edge was rough.