311
edits
Difference between revisions of "Omnindoor"
no edit summary
| Line 5: | Line 5: | ||
| Pin || thing || Mode in Tasmota Configure Unit menu | | Pin || thing || Mode in Tasmota Configure Unit menu | ||
|- | |- | ||
| 4 || | | 4 || lock || Relay 1 | ||
|- | |- | ||
| 32 || | | 32 || unlock || Relay 2 | ||
|- | |- | ||
| 33 || current || ADC | | 33 || current || ADC Range 1 | ||
|- | |- | ||
| Example || Example | | Example || Example | ||
| Line 22: | Line 22: | ||
Rule2 ON Power2#state=1 DO backlog Delay 50; Power2 0 ENDON | Rule2 ON Power2#state=1 DO backlog Delay 50; Power2 0 ENDON | ||
rule2 1 | rule2 1 | ||
Rule3 ON ANALOG#Voltage1> | Rule3 ON ANALOG#Voltage1>80 DO Power1 0; Power2 0 ENDON | ||
rule3 1 | rule3 1 | ||
(100 is too low, limit sometimes trips before motor starts moving, 200 is a lot) | (100 is too low, limit sometimes trips before motor starts moving, 200 is a lot) | ||
set the adc range | set the adc range | ||
AdcParam1 33, 0, 4095, 0, 100 | |||
in the console (or by curl) you can view the rules and adcparam | in the console (or by curl) you can view the rules and adcparam | ||
| Line 34: | Line 34: | ||
RSL: RESULT = {"Rule1":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":54,"Free":457,"Rules":"ON Power1#state=1 DO backlog Delay 100; Power1 0 ENDON"}} | RSL: RESULT = {"Rule1":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":54,"Free":457,"Rules":"ON Power1#state=1 DO backlog Delay 100; Power1 0 ENDON"}} | ||
CMD: rule3 | CMD: rule3 | ||
RSL: RESULT = {"Rule3":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":40,"Free":471,"Rules":"ON ANALOG#Voltage1> | RSL: RESULT = {"Rule3":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":40,"Free":471,"Rules":"ON ANALOG#Voltage1>80 DO Power1 0 ENDON"}} | ||
CMD: adcparam | CMD: adcparam | ||
RSL: RESULT = {"AdcParam1":[33,0,4095,0, | RSL: RESULT = {"AdcParam1":[33,0,4095,0,100]} | ||