Difference between revisions of "Artemis"
Jump to navigation
Jump to search
(crewated artemis page) |
m |
||
| Line 15: | Line 15: | ||
Working as of 05/31/2026 | Working as of 05/31/2026 | ||
MAC Address: 94:a4:08:a0:c0:c5 | MAC Address: 94:a4:08:a0:c0:c5 | ||
IP: 100.64.64.158 | |||
==hacking== | |||
* it was proprietary garbage so we hacked in by connecting directly to the mainboard serial port, 3.3v TX/RX at 115200 baud, and used the bootloader to get a root shell and reset the password to usually. Then enabled telnetd by renaming /etc/init.d/telnet to S23telnet | |||
==Documentation== | ==Documentation== | ||
Revision as of 19:52, 31 May 2026
Overview
Printer Name: Flashforge ARtemis
Preferred Slicer: Orca Slicer
Nozzle: 0.4mm
Bed Type: STextured
Filament: PLA, 1.75
Status
Working as of 05/31/2026 MAC Address: 94:a4:08:a0:c0:c5 IP: 100.64.64.158
hacking
- it was proprietary garbage so we hacked in by connecting directly to the mainboard serial port, 3.3v TX/RX at 115200 baud, and used the bootloader to get a root shell and reset the password to usually. Then enabled telnetd by renaming /etc/init.d/telnet to S23telnet
Documentation
Printing Tips
- Bottom uses 2.5mm M4 screws
Maintenance Log
- Telnet enabled 5/31/26