2
edits
Difference between revisions of "Beagle Bone Black"
→Configuring B.A.T.M.A.N to Mesh with Sudo Mesh
Ubiquitous (talk | contribs) |
Ubiquitous (talk | contribs) |
||
| Line 37: | Line 37: | ||
'''Mesh the planet...''' | '''Mesh the planet...''' | ||
=Configuring B.A.T.M.A.N to Mesh with Sudo Mesh= | =Configuring B.A.T.M.A.N to Mesh with Sudo Mesh= | ||
This tutorial assumes that you have your Beagle Bone configured running Debian Wheezy. | This tutorial assumes that you have your Beagle Bone configured running Debian Wheezy. It is all recommended that you disabel network-manager. | ||
Add batman module to the kernel | |||
<pre> | <pre> | ||
modprobe batman-adv | modprobe batman-adv | ||
</pre> | |||
Add B.A.T.M.A.N interface | |||
<pre> | |||
batctl if add eth0 | batctl if add eth0 | ||
</pre> | |||
Disable Wifi | |||
<pre> | |||
ifconfig wlan0 down | ifconfig wlan0 down | ||
</pre> | |||
Set MTU | |||
<pre> | |||
ifconfig wlan0 mtu 1532 | ifconfig wlan0 mtu 1532 | ||
iwconfig wlan0 mode ad-hoc essid pplsopen.net-node2node | </pre> | ||
ap CA:FE:C0:DE:F0:0D channel 11 | Turn on Ad-Hoc Mode and connect to the SSID ppslopen.net-node2node with the Mac Address CA:FE:C0:DE:F0:0D on Channel 11 | ||
<pre> | |||
iwconfig wlan0 mode ad-hoc essid pplsopen.net-node2node ap CA:FE:C0:DE:F0:0D channel 11 | |||
</pre> | |||
Connect B.A.T.M.A.N interface to Wlan | |||
<pre> | |||
batctl if add wlan0 | batctl if add wlan0 | ||
</pre> | |||
Turn on wlan0 and bat0 interfaces | |||
<pre> | |||
ifconfig wlan0 up | ifconfig wlan0 up | ||
ifconfig bat0 up | ifconfig bat0 up | ||
</pre> | |||
Connect to your network. Subject to change depending on our network's subnet | |||
<pre> | |||
ifconfig bat0 10.200.8.1 | ifconfig bat0 10.200.8.1 | ||
route add default gw 10.0.99.1 | route add default gw 10.0.99.1 | ||
</pre> | |||
Enable Port Forwarding | |||
<pre> | |||
echo 1 > /proc/sys/net/ipv4/ip_forward | echo 1 > /proc/sys/net/ipv4/ip_forward | ||
</pre> | </pre> | ||