|
|
| (62 intermediate revisions by 8 users not shown) |
| Line 1: |
Line 1: |
| == [[3DPrintingEvents|3D Printing Events]] ==
| | #REDIRECT [[Printing]] |
| * April 20. 2013 - [[Just enough sketchup to pretend you can 3d model II & Just enough slic3r to pretend you can extrude I]]
| |
| | |
| | |
| ----
| |
| | |
| | |
| ==Hardware==
| |
| | |
| We have a Type A 3D Printer.
| |
| | |
| == Documentation ==
| |
| | |
| There's an apocryphal sheet of paper with the perfect set of instructions.
| |
| It was left by the Early Ones, the Savior Jay.
| |
| We keep an electronic copy of the original on the Wiki but all new followers should read and reread the UrText in person, accompanied by a SudoRoom mentor.
| |
| | |
| <gallery widths="140px" heights="140px" perrow="4">
| |
| File:3DPrintApocryphalText1.jpg | Apocryphal Instructions page 1
| |
| File:3dPrintApocryphalText2.jpg | Apocryphal Instructions page 2
| |
| File:AncientDiagram.jpg | Close up of an ancient hand-drawn diagram by our 3D printing shepherd, Jay
| |
| </gallery>
| |
| | |
| === Adjusting the Print Beds ===
| |
| | |
| * Do not put multiple layers of tape on the glass print-bed: this makes the print-bed less "sticky"
| |
| | |
| Use the "manual control" in Repetier-Host to
| |
| * "Home" the Z (height) by clicking on the Home-Z
| |
| ** This will move the bed up until ?? switch cliks
| |
| ** the Z-Switch is pushed by a knob attached to the print bed. If you rotate the knob, it will adjust the global z-height of the print-bed
| |
| | |
| * Ensure the print nozzle is not touching the tape by pressing Z+ (move the bed down)
| |
| * "Home" the X & Y by clicking on HomeX and Home?
| |
| * Move the print head around, especially near the [holy scriptures erased] corners of the bed
| |
| * Turn the paper over
| |
| | |
| = Gallery of Creations =
| |
| | |
| <gallery widths="140px" heights="140px" perrow="4">
| |
| File:Raspberrypi3dprint.jpg | RaspBerry Pi print-out
| |
| File:Sudoroom_photo.jpg | Our Office
| |
| File:3dprintng.jpg | Creation
| |
| File:Max3DPrinting.jpg | Today I Learned Class
| |
| </gallery>
| |