Difference between revisions of "McHawking Robot Hacking"
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
* Execute the "controller.py" Python script ("./controller.py") | * Execute the "controller.py" Python script ("./controller.py") | ||
* At this point you can operate | * At this point you can operate McHawking | ||
* First set a speed setting by typing a number from 0-9 on the keyboard. "5" is a good number for getting started | * First set a speed setting by typing a number from 0-9 on the keyboard. "5" is a good number for getting started | ||
* Then press down and hold a key to start | * Then press down and hold a key to start McHawking moving. "i" is for forward (where "forward" means in the direction of the monitor. If you were sitting in the original seat of the wheelchair this would actually be "backward") | ||
Revision as of 14:51, 4 August 2013
McHawking Wheelchair Robot @ Sudo Room
Technical Details
- For all technical information please refer to the Noise-Bot page on the Noisebridge Wiki
Network
- You can SSH into !McHawking if you are physically located at Sudo Room and connected to the "sudoroom" wireless access point
- IP Address: 192.168.1.5 (details on the Sudo Room Network Page)
- username: mchawking
- password: [redacted]
Software
- Change to the "lilia" directory int he "mchawking" account's home directory ("/home/mchawking/lilia")
- Execute the "controller.py" Python script ("./controller.py")
- At this point you can operate McHawking
- First set a speed setting by typing a number from 0-9 on the keyboard. "5" is a good number for getting started
- Then press down and hold a key to start McHawking moving. "i" is for forward (where "forward" means in the direction of the monitor. If you were sitting in the original seat of the wheelchair this would actually be "backward")