Difference between revisions of "Mesh/Meraki Sparky Enclosure Design"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
* the standoff extending from the top, but short enough to clear the PCB components | * the standoff extending from the top, but short enough to clear the PCB components | ||
* the slots should be near the bottom of the box | * the slots should be near the bottom of the box | ||
* the opening should have a curved front to | * the opening should have a curved front to accommodate the angled ethernet/power connections | ||
* the back should have a mounting hole for the antenna | * the back should have a mounting hole for the antenna | ||
Revision as of 23:49, 5 December 2013
See Also: Mesh/Inventory
notes about an enclosure for the Maraki Sparky
first pass
The idea is for an enclosure that has a slot on the sides into which the Meraki Sparky can slide. Then there might be a single screw that can be inserted from the bottom in order to keep the PCB from sliding out. Next design should have:
- the standoff extending from the top, but short enough to clear the PCB components
- the slots should be near the bottom of the box
- the opening should have a curved front to accommodate the angled ethernet/power connections
- the back should have a mounting hole for the antenna