Difference between revisions of "TAZ 4"
(Created page with "Sudoroom has a TAZ 4 3d printer, that was donated in 2022. It should not be confused with the older TAZ 3 3d printer, which doesn't work very well as a 3D printer. [https://download.lulzbot.com/TAZ/4.0/ Documentation for the TAZ 4 from Lulzbot corporation] thumb The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only") |
|||
| Line 1: | Line 1: | ||
Sudoroom has a TAZ 4 3d printer, that was donated in 2022. It should not be confused with the older TAZ 3 3d printer, which | Sudoroom has a TAZ 4 3d printer, that was donated in 2022. It should not be confused with the older TAZ 3 3d printer, which didn't work very well as a 3D printer. | ||
[https://download.lulzbot.com/TAZ/4.0/ Documentation for the TAZ 4 from Lulzbot corporation] | [https://download.lulzbot.com/TAZ/4.0/ Documentation for the TAZ 4 from Lulzbot corporation] | ||
| Line 5: | Line 5: | ||
[[File:Taz4-3d-printer.jpg|thumb]] | [[File:Taz4-3d-printer.jpg|thumb]] | ||
The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only | The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only | ||
The TAZ 4 uses an [https://reprap.org/wiki/Rambo Ultimachine Rambo 1.3L main board] | |||
[Image:https://reprap.org/wiki/File:Rambo-conn-all.jpg] | |||
The original 14-pin "Extruder 0" connector on the TAZ4 was removed from "Aux Power Mosfet Output" (pins 5/red,6/black), E0 Heat (pins 12,13), E0 Fan (9/black,10/red) and Ground (pin 2), and E0 (3,7,11,14). The extruder harness from the TAZ3 was installed in it. | |||
Revision as of 23:54, 11 June 2022
Sudoroom has a TAZ 4 3d printer, that was donated in 2022. It should not be confused with the older TAZ 3 3d printer, which didn't work very well as a 3D printer.
Documentation for the TAZ 4 from Lulzbot corporation
The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only
The TAZ 4 uses an Ultimachine Rambo 1.3L main board [Image:https://reprap.org/wiki/File:Rambo-conn-all.jpg] The original 14-pin "Extruder 0" connector on the TAZ4 was removed from "Aux Power Mosfet Output" (pins 5/red,6/black), E0 Heat (pins 12,13), E0 Fan (9/black,10/red) and Ground (pin 2), and E0 (3,7,11,14). The extruder harness from the TAZ3 was installed in it.
