Difference between revisions of "Beagle Bone Black"
Jump to navigation
Jump to search
Ubiquitous (talk | contribs) |
|||
| Line 36: | Line 36: | ||
<br><br><br> | <br><br><br> | ||
'''Mesh the planet...''' | '''Mesh the planet...''' | ||
=Configuring B.A.T.M.A.N to Mesh with Sudo Mesh= | |||
This tutorial assumes that you have your Beagle Bone configured running Debian Wheezy. | |||
<pre> | |||
modprobe batman-adv | |||
batctl if add eth0 | |||
ifconfig wlan0 down | |||
ifconfig wlan0 mtu 1532 | |||
iwconfig wlan0 mode ad-hoc essid pplsopen.net-node2node \ | |||
ap CA:FE:C0:DE:F0:0D channel 11 | |||
batctl if add wlan0 | |||
ifconfig wlan0 up | |||
ifconfig bat0 up | |||
ifconfig bat0 10.200.8.1 | |||
route add default gw 10.0.99.1 | |||
echo 1 > /proc/sys/net/ipv4/ip_forward | |||
</pre> | |||
Revision as of 20:07, 17 June 2014
See Also: Mesh/Hardware Fourth Milestone
notes about BBB - Beagle Bone Black
OS Install
OpenWRT
Adafruit tutorial
https://learn.adafruit.com/beaglebone-black-installing-operating-systems/angstrom
first light
Just booting up...
using an FTDI device plugged into J1 pins
find the serial port for the FTDI USB adapter
ls /dev/tty*
- might be /dev/ttyAMA0 on linux
- might be /dev/tty.usbmodemfa133 on mac
Wiring from the FTDI device:
- BBB - FTDI
- pin 1 GND - GND
- pin 4 RX - TX
- pin 5 TX - RX
in terminal:
screen <usbdevicename> 115200
- first login with root, no password
Mesh the planet...
Configuring B.A.T.M.A.N to Mesh with Sudo Mesh
This tutorial assumes that you have your Beagle Bone configured running Debian Wheezy.
modprobe batman-adv batctl if add eth0 ifconfig wlan0 down ifconfig wlan0 mtu 1532 iwconfig wlan0 mode ad-hoc essid pplsopen.net-node2node \ ap CA:FE:C0:DE:F0:0D channel 11 batctl if add wlan0 ifconfig wlan0 up ifconfig bat0 up ifconfig bat0 10.200.8.1 route add default gw 10.0.99.1 echo 1 > /proc/sys/net/ipv4/ip_forward