Artemis

Overview

Ender 3 Pro

Printer Name: Flashforge ARtemis

Preferred Slicer: Orca Slicer

Nozzle: 0.4mm

Bed Type: STextured

Filament: PLA, 1.75

Status

Being hacked as of 05/31/2026

hacking

• it was proprietary garbage so we hacked in by connecting directly to the mainboard serial port, 3.3v TX/RX at 115200 baud, and used the bootloader to get a root shell and reset the password to usually. Then enabled telnetd by renaming /etc/init.d/telnet to S23telnet

MAC Address: 94:a4:08:a0:c0:c5 IP: 100.64.64.158

next steps

• printer is on /dev/tty/S2, baud rate 115200
• running linux 3.10.65

Printing Tips

• Bottom uses 2.5mm M4 screws

Maintenance Log

• Telnet enabled 5/31/26