This page has been marked as stale, as it is outdated to the point of providing significant misinformation. Please update it before linking other pages here.
As of June 2018, we just reorganized the mesh cage. A more recent and up-to-date inventory of our materials is underway, but will likely be hosted elsewhere. Link to follow.
current-gen nodes
ready for outdoor mounting
NOTE: UPDATE WITH NEW DONATIONS AS OF 10/2017
- 1x Nanobridge M5 (25 dB version)
- 3x Nanobridge M5 (22 dB version)
- 3x Nanostation M5
- 1x Nanostation M2
- 2x Rocket M5 and 2x 90 degree panel antenna (one antenna already on rooftop)
All of these are complete (with PoE).
ready for indoor use
- ~150x Western Digital MyNet N750s or N600s
All of these are complete (with power supply).
used gear
- Some Bullet M2s and some Bullet M5s. Need to count.
previous-gen nodes
used gear
- Maybe ~15x Picostation 2HP ?
- A bunch of Bullet 2HP
incomplete gear
- More than 100x Meraki sparky (also known as Meraki outdoor)
- No cases, power supplies or antennas (u.fl connector)
- Needs special script for hardware watchdog.
- Flashing takes ~20 mins
PoE adapters
- ?
Cable
Ethernet
- Maybe 1/4 roll of a 100 foot outdoor UV-protected shielded and grounded CAT6
- A bunch of indoor CAT5 and CAT5E
- Bunch of RJ45 connectors
- Bunch of grounded RJ45 connectors
Antennas and pigtails
We have a bunch of high-gain omnis, a bunch of dish (the grid type) antennas, and a few panel antennas. Most of these are N connectors. We need to go through them, check frequency and tag them with frequency.
We have a bunch of u.fl to male N pigtails.
We have a bunch of GPS antennas.
Tools for node-mounting
Big tools
- One foldable woodworking table (like this)
Hand tools
- One decent RJ45 crimper (blue handle) with somewhat worn out cutting blades
- 2x low quality RJ45 crimpers (green handle). Probably OK for crimping but not for cutting or stripping.
- A set of screwdrivers, wire cutter, tongs, and other basic hand tools.
Power tools
- Makita impact driver (battery powered)
- Makita drill (battery powered)
- Makita battery charger
- 3x Makita batteries
Testing
- Two ethernet cable testers (need batteries)
Consumables for node-mounting
TODO put stuff like mounting brackets, plumbers tape, screws, silicone, hose clamps, cable staples.
Other stuff
- 3x One Laptop Per Child XO Laptop (one power supply)
- Lots of other stuff that needs.
Less than useful stuff
- A bunch of random indoor routers that don't support OpenWRT
- A bunch of random indoor routers that do support modern OpenWRT but no two are alike
- A great big stack of the original blue linksys routers. These only support old versions of OpenWRT.