Difference between revisions of "Mesh/WalkThrough"

Mesh/WalkThrough (view source)

293 bytes added , 20:05, 4 May 2016

128

edits

@@ Line 92: / Line 92: @@
 = Configuring Your OpenWRT Router to Work on the Sudomesh Network =
-These are the steps for configuring your newly flashed router. It will retrieve hardware information about the node, prompt you for a few config settings, and then query the meshnode database to get an available IP address and subnet.
+After you have successfully flashed your router with the OpenWRT, you will need to use [makenode https://github.com/sudomesh/makenode] to complete the setup. makenode registers your node on the SudoMesh network, resulting in the assignment of a 64 IPv4 address subnet to your node, in addition to applying basic configuration.
-Open your terminal and type:
+From your terminal, run the following:
    git clone https://github.com/sudomesh/makenode.git
@@ Line 108: / Line 108: @@
 * Subnet mask:  255.255.255.0
 * Gateway: 0.0.0.0
+See Network Configuration Guides: [https://sudoroom.org/wiki/Mesh/Network%20Configuration%20for%20Linux Linux] [https://sudoroom.org/wiki/Mesh/Network%20Configuration%20for%20MacOS%20X Mac]
 == Linux ==