128
edits
Difference between revisions of "Mesh/Flashing extender nodes"
→Serial Communications Program
Redconfetti (talk | contribs) |
Redconfetti (talk | contribs) |
||
| Line 102: | Line 102: | ||
Reboot the device, and it will let you drop into a command line. You will then have to figure out how to enable the network from the boot loader (Uboot or Redboot) and transfer the firmware to the device to flash it. | Reboot the device, and it will let you drop into a command line. You will then have to figure out how to enable the network from the boot loader (Uboot or Redboot) and transfer the firmware to the device to flash it. | ||
==== Interupting Boot ==== | |||
You'll need to make sure to press a key before it boots the default image. | |||
U-Boot 1.1.4-s958 (Jun 10 2015 - 10:56:20) | |||
DRAM: 64 MB | |||
Flash: 8 MB (0xc2, 0x20, 0x17) | |||
Net: AR8236 | |||
eth0, eth1 | |||
Board: Ubiquiti Networks AR9342 board (e855-22585.1122.0030) | |||
Radio: 0777:e855 | |||
Reset: Normal | |||
Hit any key to stop autoboot: 0 | |||