30
edits
Difference between revisions of "Sewing"
Fix log of getting Lotus 1000 to work
(Adding more info about machines here) |
(Fix log of getting Lotus 1000 to work) |
||
| Line 1: | Line 1: | ||
== | == Getting started sewing == | ||
[http://www.wikihow.com/Use-a-Sewing-Machine#_note-1 Wikihow to use a sewing machine with animated pictures] | |||
== Functional sewing machines == | |||
=== Lotus 1000 Sewing Machine === | |||
White desktop Unit. | |||
== Industrial Sewing machine - Juki DLN-415-4 == | == Sewing machines needing a little love == | ||
=== Industrial Sewing machine - Juki DLN-415-4 === | |||
We have a Juki DLN-415-4 Industrial Sewing machine, with desk, but missing the oil reservoir/tray. | We have a Juki DLN-415-4 Industrial Sewing machine, with desk, but missing the oil reservoir/tray. | ||
| Line 12: | Line 16: | ||
The kind of oil is [http://www.amazon.com/Genuine-Defrix-Sewing-Machine-600ml/dp/B00D2DIZ4K/ref=cm_cr_arp_d_product_top Juki Genuine Defrix Sewing Machine Oil No.1]. However, we have Stainless "Lily White" sewing machine oil which looks similar and was used. | The kind of oil is [http://www.amazon.com/Genuine-Defrix-Sewing-Machine-600ml/dp/B00D2DIZ4K/ref=cm_cr_arp_d_product_top Juki Genuine Defrix Sewing Machine Oil No.1]. However, we have Stainless "Lily White" sewing machine oil which looks similar and was used. | ||
* +4 Others probably in better condition? | |||
== Fix log == | |||
=== Background info === | |||
* [http://www.theatlantic.com/technology/archive/2013/11/how-a-sewing-machine-works-explained-in-a-gif/281403/ Gif of how it works] | |||
Timing was broken on Lotus 1000 Sewing Machine. The needle would dip to its lowest point but it wouldn't be caught and wound around the second thread from the bobbin. | |||
To fix it, we took off the front storage for thread (lift and roll to the right), then took off the bottom. Once the bottom was exposed, the holder of the bobbin was anchored with three screws to the shaft. By loosening these, the bobbin cage can rotate independently of the shaft. To align the timing, we put the needle at the lowest point and the claw of the bobbin cage just about to catch it. Once aligned, the three screws must be tightened while keeping the axle tight to maintain good gear contact. A trick to keep this easy was to only turn by hand in the "forward" direction (counter clockwise looking down on the dial). This keep the teeth of the gears in nice contact. Then the bobbin cage was held in a known place while the needle was rotated down its lowest. Finally, the three screws were tightened. Make sure to do some test sewing before putting it all back togetherr! | |||