Sudo Room

Difference between revisions of "Monoprice Select Mini V2"

Monoprice Select Mini V2 (view source)

Revision as of 15:40, 29 February 2024

258 bytes added ,  29 February
Created page with "The small 3D printer on the main tables is hard to name. According to Simon: "I tried Prusa Slicer at first but then I found out that Cura has settings for the printer built in so I switched to that. In Cura the printer is called Monoprice Select Mini V2""
(Created page with "The small 3D printer on the main tables is hard to name. According to Simon: "I tried Prusa Slicer at first but then I found out that Cura has settings for the printer built in so I switched to that. In Cura the printer is called Monoprice Select Mini V2"")
 
(No difference)
Retrieved from "https://sudoroom.org/wiki/Special:MobileDiff/12415"