14
edits
Difference between revisions of "Artillery Sidewinder X2"
m
screenshot formatting
(PETG printing tips) |
m (screenshot formatting) |
||
| Line 9: | Line 9: | ||
* This printer works great with '''PLA''' filament. It should be '''1.75mm''' diameter. If you find a spool that has both of those on the label, very likely to work. As of 9/2024 there is a small blue spool floating around that definitely works. | * This printer works great with '''PLA''' filament. It should be '''1.75mm''' diameter. If you find a spool that has both of those on the label, very likely to work. As of 9/2024 there is a small blue spool floating around that definitely works. | ||
* Small spools can hang off the clamp stuck on top the right support. 1KG and larger spools feed better from the built-in holder center-top, but you may need to adjust it to the correct width for the spool. The hex key needed to adjust the bracket should be in the "Tools" drawer next to the printer. | * Small spools can hang off the clamp stuck on top the right support. 1KG and larger spools feed better from the built-in holder center-top, but you may need to adjust it to the correct width for the spool. The hex key needed to adjust the bracket should be in the "Tools" drawer next to the printer. | ||
* The stock [https://github.com/prusa3d/PrusaSlicer PrusaSlicer] profiles for the Artillery X1 w/ Generic PLA seem to work pretty well. The Generic PETG profiles '''DO NOT''' work great with this printer; | * The stock [https://github.com/prusa3d/PrusaSlicer PrusaSlicer] profiles for the Artillery X1 w/ Generic PLA seem to work pretty well. The Generic PETG profiles '''DO NOT''' work great with this printer; see below. | ||
===PETG Printing=== | ===PETG Printing=== | ||
[[File:Artillery-petg-settings.png|thumb]] | |||
The attached screenshot shows some overrides for PETG printing. | |||
The problems these are trying to solve are: | The problems these are trying to solve are: | ||