342
edits
Difference between revisions of "TAZ 4"
no edit summary
| Line 6: | Line 6: | ||
<code>M907 E150</code>'''</big> | <code>M907 E150</code>'''</big> | ||
[[File: | [[File:720px-Rambo-conn-all.jpg|thumb]] | ||
The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only | The extruder head from the TAZ 3 was transferred onto the TAZ 4 which will presumably make a better 3D printer. The TAZ 3 will be converted for solder paste dispensing only | ||
[[File:Taz4-3d-printer.jpg|720px]] | |||
The TAZ 4 uses an [https://reprap.org/wiki/Rambo Ultimachine Rambo 1.3L main board] and here is the correct [[File:RAMBo_1.3L_Schematic.pdf|RAMBo_1.3L_Schematic]] | The TAZ 4 uses an [https://reprap.org/wiki/Rambo Ultimachine Rambo 1.3L main board] and here is the correct [[File:RAMBo_1.3L_Schematic.pdf|RAMBo_1.3L_Schematic]] | ||
The original 14-pin "Extruder 0" connector on the TAZ4 was removed from "Aux Power Mosfet Output" (pins 5/red,6/black), E0 Heat (pins 12,13), E0 Fan (9/black,10/red) and Ground (pin 2), and E0 (3,7,11,14). The extruder harness from the TAZ3 was installed in it. | The original 14-pin "Extruder 0" connector on the TAZ4 was removed from "Aux Power Mosfet Output" (pins 5/red,6/black), E0 Heat (pins 12,13), E0 Fan (9/black,10/red) and Ground (pin 2), and E0 (3,7,11,14). The extruder harness from the TAZ3 was installed in it. | ||