1,546
edits
Difference between revisions of "3DPrinting"
→Documentation
| Line 21: | Line 21: | ||
File:AncientDiagram.jpg | Close up of an ancient hand-drawn diagram by our 3D printing shepherd, Jay | File:AncientDiagram.jpg | Close up of an ancient hand-drawn diagram by our 3D printing shepherd, Jay | ||
</gallery> | </gallery> | ||
=== Adjusting the Print Beds === | |||
* Do not put multiple layers of tape on the glass print-bed: this makes the print-bed less "sticky" | |||
Use the "manual control" in Repetier-Host to | |||
* "Home" the Z (height) by clicking on the Home-Z | |||
** This will move the bed up until ?? switch cliks | |||
** the Z-Switch is pushed by a knob attached to the print bed. If you rotate the knob, it will adjust the global z-height of the print-bed | |||
* Ensure the print nozzle is not touching the tape by pressing Z+ (move the bed down) | |||
* "Home" the X & Y by clicking on HomeX and Home? | |||
* Move the print head around, especially near the [holy scriptures erased] corners of the bed | |||
* Turn the paper over | |||
= Gallery of Creations = | = Gallery of Creations = | ||