Difference between revisions of "Mesh/WalkThrough"
no edit summary
| Line 9: | Line 9: | ||
== Install TFTP == | == Install TFTP == | ||
verify that you have TFTP installed | verify that you have TFTP installed | ||
sudo apt-get update | |||
sudo apt-get install tftp | |||
== Download the correct firmware == | == Download the correct firmware == | ||
For the supported routers, please find the latest firmware here: | For the supported routers, please find the latest firmware here: | ||
http://build.sudomesh.org/latest_image/ | |||
=Installing OpenWRT= | =Installing OpenWRT= | ||
| Line 28: | Line 28: | ||
==Step One: Reset the router== | ==Step One: Reset the router== | ||
===PicoStation=== | |||
- Turn off the device | |||
- Press the reset button | |||
- Turn on the device | |||
- Release the reset button ~10 seconds (but not longer) after turning the device on. You will know it's ready when the LEDs change. | |||
- Ping 192.168.1.20. If it works, you're ready to upload an image, | |||
===Bullet=== | |||
- Press and hold the reset button while plugging in the powered ethernet cable. | |||
- Keep holding the reset button. Look at the LED above the power LED. | |||
- It will go from one green light, to two, the start flashing orange and red | |||
- Release the reset button when it turns on the second time. | |||
The Bullet will now be running a TFTP server 192.168.1.20 | The Bullet will now be running a TFTP server 192.168.1.20 | ||