188
edits
Difference between revisions of "Rooftop Dish Antenna Mount"
Rooftop Dish Antenna Mount (view source)
Revision as of 22:33, 22 November 2014
, 22:33, 22 November 2014no edit summary
| Line 5: | Line 5: | ||
[[Category:Antenna]] | [[Category:Antenna]] | ||
[[Category:Hardware]] | [[Category:Hardware]] | ||
== Overview == | |||
The basic concept for this mounting is to provide a sturdy stand with minimum impact on the roof. There is an attic air vent near the peak of the roof around which it will be possible to hang the assembly. A braided steel wire about 20' long should be sufficient. | |||
The design uses a 4x4 piece of 1/2" plywood with a 2' 2x4 standing straight up and braced with 1/4" plywood triangles. The roof has an average slope at about 18 degrees so there are 3 cuts that must be made at that angle. | |||
See the diagrams below. | |||
== Parts == | == Parts == | ||