Omnindoor

Caption text

Pin	thing	Mode in Tasmota Configure Unit menu
4	lock	Relay 1
32	unlock	Relay 2
33	current	ADC Range 1
Example	Example

curl -u "admin:password" http://10.111/cm?cmnd=power1+1

rules so that motor direction gets activated, with a timeout. But if current limit hits, then cancel

Rule1 ON Power1#state=1 DO backlog Delay 50; Power1 0 ENDON
rule1 1
Rule2 ON Power2#state=1 DO backlog Delay 50; Power2 0 ENDON
rule2 1
Rule3 ON ANALOG#Voltage1>80 DO Power1 0; Power2 0 ENDON
rule3 1
(100 is too low, limit sometimes trips before motor starts moving, 200 is a lot)

set the adc range
AdcParam1 33, 0, 4095, 0, 100

in the console (or by curl) you can view the rules and adcparam

CMD: rule1
RSL: RESULT = {"Rule1":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":54,"Free":457,"Rules":"ON Power1#state=1 DO backlog Delay 100; Power1 0 ENDON"}}
CMD: rule3
RSL: RESULT = {"Rule3":{"State":"ON","Once":"OFF","StopOnError":"OFF","Length":40,"Free":471,"Rules":"ON ANALOG#Voltage1>80 DO Power1 0 ENDON"}}
CMD: adcparam
RSL: RESULT = {"AdcParam1":[33,0,4095,0,100]}