289
edits
Difference between revisions of "TAZ 4"
add information about firmware and digipot current controls
(add information about firmware and digipot current controls) |
|||
| Line 12: | Line 12: | ||
The TAZ 4 didn't work because both Fuse F2 and F3 on the RAMBO main board were missing. They're supposed to be [https://www.littelfuse.com/products/fuse-blocks-fuseholders-and-fuse-accessories/fuse-blocks/154.aspx Littelfuse OMNI-BLOK 154 series] and we didn't have any, so I stuck 5-amp [https://www.digikey.com/en/products/detail/littelfuse-inc/0466005-NR/521341 F1460CT-ND] in there since we have dozens of them in the FUSES bin: [[Image:Taz4_fuse_kludge.jpg|thumb|left]] | The TAZ 4 didn't work because both Fuse F2 and F3 on the RAMBO main board were missing. They're supposed to be [https://www.littelfuse.com/products/fuse-blocks-fuseholders-and-fuse-accessories/fuse-blocks/154.aspx Littelfuse OMNI-BLOK 154 series] and we didn't have any, so I stuck 5-amp [https://www.digikey.com/en/products/detail/littelfuse-inc/0466005-NR/521341 F1460CT-ND] in there since we have dozens of them in the FUSES bin: [[Image:Taz4_fuse_kludge.jpg|thumb|left]] | ||
And now it turns on and mostly works, but the extruder stepper is mostly skipping. Most likely the current needs to be adjusted for the extruder stepper driver, which is something we have to read the manuals to figure out how to do - there are no tiny potentiometers to adjust on this RAMBO board, only a "digipot" | And now it turns on and mostly works, but the extruder stepper is mostly skipping. Most likely the current needs to be adjusted for the extruder stepper driver, which is something we have to read the manuals to figure out how to do - there are no tiny potentiometers to adjust on this RAMBO board, only a "digipot". | ||
The digipots are controlled with the [https://marlinfw.org/docs/gcode/M907.html M907 command] | |||
The following start code should be entered until we can recompile the [https://download.lulzbot.com/TAZ/4.0/software/current/firmware/Marlin/ firmware] | |||
<code>M907 E150</code> | |||
the default values are found in | |||
<code>Configuration_adv.h:#define DIGIPOT_MOTOR_CURRENT {175,175,240,135,135} // Values 0-255 (RAMBO 135 = ~0.75A, 185 = ~1A) | |||
pins.h:#define DIGIPOT_CHANNELS {4,5,3,0,1} // X Y Z E0 E1 digipot channels to stepper driver mapping</code> | |||