[sudo-discuss] OK to borrow 3d printer for a few days?
Yardena Cohen
yardenack at gmail.com
Wed Sep 21 12:33:40 PDT 2016
On Wed, Sep 21, 2016 at 1:07 PM, <hol at gaskill.com> wrote:
> Trying here - noticed after I set it up at home that bead does not heat. No
> voltage on the terminals inside the controller either, is there a setting
> that can be changed via USB but not via the lcd screen menu? I always just
> print from SD, noticed the temperature settings were off to vs. last time I
> used it so will try this route. Nozzle is heating up just fine so assuming
> power is nominal and it's a software issue.
Bed heat is controlled by gcode. Make sure your slicer is set for it.
More information about the sudo-discuss
mailing list