[sudo-discuss] OK to borrow 3d printer for a few days?

[hol at gaskill.com]

It is, have been using a modified version of mfgr's ABS print settings 
in slic3r as always and it shows up as the target temp on the lcd screen 
of the printer, just no voltage at the terminal for the heating element. 
  Installing latest version of Cura now to rule out gcode issues.

On 2016-09-21 12:33, Yardena Cohen wrote:
> On Wed, Sep 21, 2016 at 1:07 PM,  <hol at gaskill.com> wrote:
>> Trying here - noticed after I set it up at home that bead does not 
>> heat.  No
>> voltage on the terminals inside the controller either, is there a 
>> setting
>> that can be changed via USB but not via the lcd screen menu?  I always 
>> just
>> print from SD, noticed the temperature settings were off to vs. last 
>> time I
>> used it so will try this route.  Nozzle is heating up just fine so 
>> assuming
>> power is nominal and it's a software issue.
> 
> Bed heat is controlled by gcode. Make sure your slicer is set for it.